When the XTENDER solves your setup problem
The TRX XTENDER is an extension strap that gives you more length when your suspension trainer's anchor point is out of comfortable reach. According to the product record, it is suggested when the anchor point is 9 ft or more off the ground, or when the anchor point has a thick circumference, like a tree or a pole.
That makes the XTENDER a practical add-on for outdoor training or any space where the ideal anchor is high or bulky. It is not a replacement for the anchor itself; the record describes it as the partner for the TRX Suspension Anchor.
How to install the XTENDER
The supplied instructions are brief, so keep the setup simple and focus on the two supported actions.
- Loop or attach the XTENDER to the anchor point: The record states: 'To use, loop around or attach the Xtender to your elevated anchor point.' Choose the method that matches your anchor.
- Connect your suspension trainer: The XTENDER is designed to work with your TRX Suspension Anchor and suspension trainer. The record does not describe a specific connector, so follow the setup that matches your anchor hardware.
- Add a second XTENDER if you need more length: The record says you can double up on the Xtenders, and for greater lengths, simply join two or more Xtenders together.
One XTENDER or two? Use the circumference guidance
The product record gives a clear rule of thumb based on the anchor's circumference, not its height.
- One XTENDER: Recommended for anchor points under 25” in circumference.
- Two or more combined XTENDERS: Recommended for larger anchor points, such as wide tree trunks or thick poles.
Anchor height: what the record does and does not say
The catalog suggests the XTENDER when the anchor point is 9 ft or more off the ground. That is the only height guidance supplied. It does not specify a maximum height, a minimum height, or a required distance from the anchor to the trainer.
If your anchor is lower than 9 ft but unusually thick, the circumference guidance still applies. If your anchor is high but slender, the height suggestion is the relevant one. In either case, the record's claim is that no anchor point is too high or too wide when you use the XTENDER as intended.
TRX XTENDER at a glance
- TRX XTENDER: Size: 37"L This is the length of one XTENDER, which helps you judge whether a single strap or a joined pair suits your anchor.

TRX XTENDER - TRX XTENDER: Suggested to use when the anchor point is 9 ft or more off the ground, or when your anchor point has a thick circumference - like a tree or a pole. This is the catalog's own trigger for choosing the XTENDER over a standard setup.
- TRX XTENDER: Recommend using one TRX Xtender for anchor points under 25” in circumference and two or more combined Xtenders for larger anchor points. This gives you a concrete way to decide how many straps to bring.
- TRX XTENDER: One Xtender comes with the Pro4, Pro4 Digi Camo, and Tactical Suspension Trainers. If you already own one of those kits, check your box before buying a separate XTENDER.
What the catalog leaves for you to confirm
The record does not describe a weight limit, a specific connector type, or a maximum number of joined XTENDERS. It also does not give a step-by-step safety inspection routine. Treat those as open questions and check your anchor and hardware before each session.
The XTENDER is available in a Standard variant. The catalog does not list other sizes, so the 37"L figure is the only length supplied.


